Miller Spectrum 625 Plasma Cutter, 5/8" cut cap

Features

LVC™ line voltage compensation provides peak performance power under variable conditions (187 to 264 volts) for steady and cleaner ending cuts.
Power factor correction(PFC) uses input power more efficiently, ultimately using less energy.
Wind Tunnel Technology™ Internal air flow that protects electrical components and PC boards from dirt, dust, debris... greatly improving reliability.
Fan-On-Demand™ cooling system only operates when needed, reducing the amount of airborne dust/dirt pulled through the unit.
Can be powered by any Miller engine drive with generator power (e.g. Bobcat™) or equivalent competitive equipment.
Starts without high-frequency so it will not interfere with or damage controls or computers.
Pilot Arc Controller improves tip life and maintains uninterrupted operation when cutting expanded metal or grating.
Miller's rugged ICE-40C torch provides a rated cut of 1/2 in (12 mm), longer consumable life, and a torch cable that is more resistant to burns and cuts.
Post Flow Cooling Circuit Protection to extend the life of consumables and the cutting torch is enhanced by our post flow circuit that provides cooling gas after you release the trigger.

Plasma cutter
ICE-40C hand-held torch with 25 ft (7.6 m) or 50 ft (15.2 m) cable
Heavy-duty work clamp with 25 ft(7.6 m) or 50 ft(15.2 m) cable.
12 ft (3.7 m) industrial power cord and plug
Extra consumables (3 electrodes, 3 tips and 1 air fitting)

Cutting Capability:

Rated: 1/2 in (13mm)

Quality: 5/8 in (16mm)

Sever: 7/8 in (22mm)
Input Power: 208 - 230 V 1 Phase
Input Amperage Circuit Requirement: 230 volt, 35 amp (min.) individual branch circuit
Compressor Requirement: 6.0 CFM (170 L/min.) at 100 PSI (689 kPa)
Rated Output at 104° F (40°C): 40 A at 140 VDC, 50% duty cycle