Millermatic 140 MIG Welder w/Auto-Set
Features
- Auto-Set™ features the breakthrough control that automatically sets your welder to the proper parameters. It works with .024 and .030 in solid steel wire, (75% argon/25% CO2) shielding gas, and provides all-in-one MIG , minus the guesswork. Just set the wire size, set the material thickness, and start welding.
- New! Spool gun compatibility makes for reliable and economical aluminum welding
- Smooth-Start™ technology provides a smooth, spatter-free start.
- Infinite Voltage Control with Manual On/Off Wire Feed Speed Tracking
- Miller's Exclusive "Tip Saver" Short Circuit Protection
- Durable Cast Aluminum Feedhead
- Factory-installed Gas Solenoid Valve
- Standard Built-in Solid-State Contactor Circuit
- Thermal Overload Protection
- Easy access to output studs provides easy switching between solid or flux cored wires
- Self-resetting Motor Protection Circuit
- Uses 4 or 8 in (102 or 203 mm) spools
Comes with the following
- 6 ft (1.8m) power cord and plug
- 10 ft (3 m), M-10 Miller MIG Gun and Cable Assembly #195 605
- 10 ft (3 m) Work Cable with Clamp
- Factory-installed gas solenoid valve
- Smith® Argon and AR/CO2 Mix Regulator/Flow Gauge with hose
- Spool of Hobart® .024 in (0.6mm) Solid Wire
- Two Contact Tips each for .024 in (0.6mm) & .030 in (0.8mm) Wire
- Dual Groove quick-change Drive Roll for .024 in (0.6mm) or .030/.035 in (0.8mm) Wire
- Set-up and Operational Video & Information/Settings Chart
- Material Thickness Gauge
Additional Specifications
- Rate Output
| 20% Duty Cycle: | 90A at 18 VDC |
| 20% Duty Cycle: | 63A at 21 VDC |
- Wire Feed Speed: 15 - 390 IPM
- Wire Types and Diameter
| Solid Steel: | .023 - .035 in (0.6 - 0.9 mm) |
| Stainless Steel: | .023 - .035 in (0.6 - 0.9 mm) |
| Flux Cored: | .030 - .045 in (0.8 - 1.2 mm) |
|
Test
